HYDRANFC

155.00

Description

   HYDRANFC SHORT DESCRIPTION

HYDRANFC  is a  Powerful 13.56MHz RFID / NFC platform. Read / write / crack / sniff / emulate in Direct Mode 0.World’s only real-time RFID sniffing device – allowing for advanced RFID attacks.Highly advanced tool – this is not a beginner’s device.

INTRODUCTION

The HydraNFC is an incredibly powerful and flexible 13.56MHz NFC sniffing/reading/writing/emulating platform for 13.56MHz tags.

The Hydra NFC is less expensive, more powerful/extensible than Proxmark3 Hardware and does not require an FPGA (all is done by the MCU Cortex M4F@168MHz with the help of HydraBus with an ultra-fast unique algorithm to sniff & decode in real-time PICC/PCD NFC cards).

FUNCTIONALITY IN A GLANCE

Below is a non-exhaustive list of what the HydraNFC brings to the table.

ULTRA-PORTABLE

Only 33 grams and 54x35x13 mm

FULL THROTTLE NFC INTERACTION

Direct Mode 0 access for unrestricted development

ULTRA-CAPABLE OUT OF THE BOX

Full support for all common NFC cards, real-time sniffing

TECHNICAL SPECS

In addition to all HydraNFC specifications:

  • Supports Near Field Communication (NFC) Standards NFCIP-1 (ISO/IEC 18092) and NFCIP-2 (ISO/IEC 21481)
  • Completely Integrated Protocol Handling for ISO15693, ISO18000-3, ISO14443A/B, and FeliCa
  • Integrated Encoders, Decoders, and Data Framing for NFC Initiator, Active and Passive Target Operation for All Three-Bit Rates (106 kbps, 212 kbps, 424 kbps) and Card Emulation
  • RF Field Detector With Programmable Wake-Up Levels for NFC Passive Transponder Emulation Operation
  • Programmable System Clock Frequency Output (RF, RF/2, RF/4) from 13.56-MHz Crystal
  • Programmable Modulation Depth
  • Dual Receiver Architecture With RSSI for Elimination of “Read Holes” and Adjacent Reader System or Ambient In-Band Noise Detection
  • Programmable Output Power: +20 dBm (100 mW), +23 dBm (200 mW)
  • Support any protocols under 13.56 MHz with modulation depth OOK (100%) or ASK (from 7% to 30%)
  • Support low-level Direct Mode 0 (Raw RF Sub-Carrier Data Stream) or intermediate level (for special tags, not ISO compliant like MIFARE Classic® …) Special Direct Mode for TX and Direct Mode 1 for RX using ISO encoders/decoders without protocol framing

DETAILED FUNCTIONALITY

  • Support of microSD (FAT16/FAT32) card up to 32GB
  • Virtual Serial Port access through micro USB with VT100 terminal/shell
  • Basic UID read for Vicinity/ISO15693
  • Basic UID read for ISO14443-A/MIFARE ® card 4 or 7bytes UID
  • Read MIFARE Ultralight® tag content (full dump)
  • Tag Emulation UID ISO14443A & MIFARE Classic® 1K
  • Sniffer mode in an autonomous/stand-alone mode
  • Real-time ISO14443A sniffer mode

WHAT’S INCLUDED

Hardware

  • 1x HydraBus (60mm x 37mm)
  • 1x HydraNFC Shield
  • 1x Case
  • 1x Pre-tuned Antenna

SHIPPING & PACKAGING

  • Each HydraNFC is dispatched from Europe – no need to worry about slow shipping times, import duties or damaged goods.
  • Packed in a sturdy compact box.
  • We provide worldwide shipping with express options.

If you are an educational facility, reseller or need several units, please contact us.

HYDRANFC RESOURCES

Technical Documents

HydraNFC Tutorials

Reviews

There are no reviews yet.

Be the first to review “HYDRANFC”

Your email address will not be published. Required fields are marked *

Translate »
top